Braun Stimuplex HNS 11 HNS 11 User Manual download pdf (Page 5)

In the operating mode, the LCD display shows the preselected

stimulation current set on the controller between 0.00 and

approx. 1.00 mA (in the 1 mA range) or from 0.00 to approx.

5.00 (in the 5 mA range). In the operating mode, the Stimu-

plex

HNS 11 shows the stimulation current actually flowing

via the stimulation electrodes through the tissue. A ”+” sign on

the LCD display signals this setting. The operating mode is

switched by pressing the ”mA” button.

3. Select operating mode . Set the controller to 5 mA max. and

try to get a connection with the insulated, black 2 mm male plug

with a part of the red clamp. Compare – by briefly switching to

operating mode – the measured value with the set value (ac-

tual value and set value). These two values must be the same –

with shorted cables. Reset to 1 mA max. and compare these two

values (see Measuring Accuracy in Appendix A, if neccessary).

symbol appears next to the ▲ symbol in the LCD display

(Display) and the pulsed LED display (orange light-emitting di-

ode) blinks according to the stimulation frequence.

A "+" sign appears

in front of each measurement displayed.

When a current is set at

O, the

orange LED starts to blink at 0.02

mA, when 1 mA max. is set, and at 0.10 mA when 5 mA max. is

set.

4. When the stimulation cable is disconnected (when is set),

+0.00 appears in the display and the

symbol disappears. The

pulsed LED display is no longer lit.

If the "BAT" symbol appears in the display, then the battery

voltage is getting too low. Current application can be complet-

ed without a problem, but exchanging the battery afterwards

should be considered. Press the "BAT" button to display the re-

maining battery voltage (in volts).

When the battery voltage is approx. 6 volts, three horizontal

dashes preceded by the "+" sign (or four dashes) appear in the

display in addition to the "BAT" symbol. In this case, the stimu-

lator shuts off automatically.

To avoid having to abort a stimulator treatment, you should

replace the 9 volt block battery as soon as the battery volt-

age drops to 6.5 volts.

5. To switch off the nerve stimulator, turn the control knob anti-

clockwise to position O.

To conserve the battery always switch off the Stimuplex

HNS 11

after use. If you do not use it for a long period of time, remove

the battery to prevent battery leakage.

1 2 3 4 5 6 7 8 9 10 ... 27 28

Comments to this Manuals

No comments

Braun Stimuplex HNS 11 HNS 11 User Manual Page 5

Comments to this Manuals