Braun 5647 User Manual download pdf (Page 8)

Cleaning

Never use water to clean the shaver.

For easy cleaning after each shave, switch the shaver off.

Press the release buttons to lift the shaver foil (do not

remove the foil completely). Switch on the shaver for

approx. 5–10 seconds so that the shaved stubbles can

fall out.

Then remove the shaver foil and tap it out on a flat surface.

Using the brush, clean the inner area of the pivoting head.

However, do not clean the shaver foil nor the cutter block

with the brush as this may damage them.

Put a drop of light machine oil onto the long hair trimmer

and the shaver foil.

Replacement light for shaving parts / Reset

To maintain 100% shaving performance, replace your foil

and cutter block, when the replacement light for shaving

parts (9) comes on (after about 18 months) or when worn.

Change both parts at the same time for a closer shave with

less skin irritation.

(Shaver foil and cutter block: 8000 series)

The replacement light will remind you during the next 7

shaves to replace the shaving parts. Then the shaver will

automatically reset the display.

After you have replaced the shaving parts (foil and cutter

block), use a ball-pen to push the reset button (10) for at

least 3 seconds to reset the counter.

While doing so, the replacement light blinks and goes off

when the reset is complete. The manual reset can be done

at any time.

fix

off

oil

fix

off

fix

off

0...20

replace foil

8000

Series

360°Complete

5647448_Com_8975_NA Seite 8 Donnerstag, 16. März 2006 1:41 13

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

No comments

Braun 5647 User Manual Page 8