Braun 5775 User Manual download pdf (Page 7)

7

Alternatively, you may clean the shaver using

the brush provided:

• Switch off the shaver. Remove the shaver

foil.

• Using the brush, clean the cutter block and

the inner area of the shaver head. However,

do not clean the shaver foil with the brush as

this may damage the foil.

• Put a drop of light machine oil onto the long

hair trimmer and the shaver foil.

Replacement light for shaving parts / Reset

To maintain 100% shaving performance,

replace your foil and cutter block, when the

replacement light for shaving parts (8) comes on

(after about 18 months) or when worn.

Change both parts at the same time for a closer

shave with less skin irritation.

(Shaver foil and cutter block: 5000/6000 series)

The replacement light will remind you during the

next 7 shaves to replace the shaving parts. Then

the shaver will automatically reset the display.

After you have replaced the shaving parts (foil

and cutter block), use a ball-pen to push the

reset button (9) for at least 3 seconds to reset

the counter.

While doing so, the replacement light blinks

and goes off when the reset is complete.

The manual reset can be done at any time.

Preserving the batteries

In order to maintain the optimum capacity of the

rechargeable batteries, the shaver has to be

fully discharged (by shaving) every 6 months

approximately. Then recharge the shaver to

full capacity. Do not expose the shaver to

temperatures higher than 122 °F/50 °C for

extended periods of time.

Environmental notice

This appliance is provided with nickel-

cadmium rechargeable batteries.

To protect the environment, do not

dispose of the appliance in the household

waste at the end of its useful life. Disposal can

take place at a Braun Service Center or

appropriate collection sites.

Caution: Opening the housing will destroy the

appliance and invalidate the guarantee.

Subject to change without notice.

For electric specifications, see printing on the

special cord set.

5736464_Contour_5775_NA Seite 7 Montag, 20. März 2006 1:58 13

1 2 3 4 5 6 7 8 ... 18

Comments to this Manuals

No comments