Braun SERIES 3 User Manual download pdf (Page 7)

8

small amount of oil, the cleaning procedure

also fulfills the lubrication needs of the shaver.

Important

• Only use the power supply cord set supplied

with the shaver.

• In order to avoid any leakage of the cleaning

fluid, place the appliance on a flat, stable

surface. Do not tip, move suddenly or

transport in any way if a cleaning cartridge

is installed.

• Do not place the appliance in a mirror cabi-

net, nor store it over radiators, nor place it

on polished or laquered surfaces. Do not

expose to direct sunlight.

• The appliance contains highly

flammable liquid. Keep it away from

sources of ignition. No smoking.

Keep out of reach of children. Do not refill

cartridge. Use only original Braun refill

cartridge.

• When cleaning the shaver, its protection

cap should be removed.

Description

1 Lift button for cartridge exchange

2 Contact bow

3 Start/release button

4 Level indicator

5 Cleaning cartridge

Before using Clean&Renew™

Installing the cartridge

• Press the lift button (1) to open the housing.

• Hold the cartridge down on a flat, stable

surface (e.g. table). Carefully remove the lid

from the cartridge. Slide the cartridge into

the base as far as it will go.

Slowly close the housing by pushing it down

until it locks.

Replacing the cartridge

After having pressed the lift button to open the

housing, wait for a few seconds before re-

moving the used cartridge.

Before discarding the used

cartridge, make

sure to close the openings using the lid of the

new cartridge, since the used cartridge will

contain contaminated cleaning solution.

The used cartridge can be disposed in the

household waste.

Operating your

Clean&Renew™

• Connect your Clean&Renew™ with the cord

set to the mains electricity supply. The

special socket at the back is adjustable to

save space. After each shave, switch the

shaver off and put it into the Clean&Renew™,

upside down and with the front showing.

• Push the start/release button (3) to lock and

connect the shaver. The cleaning process

will start. The yellow light on the shaver will

flash during the complete process (approx.

5 minutes cleaning, 4 hours drying).

• Do not interrupt the cleaning process, as it

leaves the shaver wet and not fit for use. If

interruption is needed nonetheless, press

the start/release button (3).

• When cleaning is finished, the yellow light

will go off and the shaver is ready for use.

To release it, push the start/release button.

• A cleaning cartridge should be sufficient

for about 30 cleaning cycles. When the level

indicator (4) has reached the «min» mark,

the remaining fluid in the cartridge is suf-

ficient for about 5 more cleaning cycles.

Then the cartridge should be replaced,

when used daily approx. every 4 weeks.

• The hygienic cleaning solution cartridge

contains alcohol which, once opened,

will naturally evaporate slowly into the

surrounding air. Each cartridge, if not used

daily should be replaced after approx.

8 weeks.

• Clean the housing from time to time with a

damp cloth, especially the opening where

the shaver rests.

Subject to change without notice.

5735322_390_AMEE Seite 8 Montag, 19. November 2007 11:59 11

1 2 3 4 5 6 7 8 ... 57

Comments to this Manuals

No comments