Braun 6690 FreeGlider User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 34
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
7
Charging the shaver
First charging:
Connect the charging stand to an elec-
trical outlet. Place the shaver into the charging stand and
allow it to charge for at least 4 hours (during charging
shaver and adapter might get warm). Once the shaver
is completely charged, disconnect the shaving stand.
Shave until fully discharged. Then reconnect and re-
charge to full capacity again (subsequent charges will
take about 1 hour).
When the shaver is completely discharged, you cannot
know if it is switched on or not. When you connect the
charging stand with the shaver to an electrical outlet,
make sure the green charging light illuminates. If it does
not, push the start/stop button (turning off the shaver).
The shaver is only charging when the green light is on.
A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth. However,
the maximum battery capacity will only be reached after
several charging/discharging cycles.
Best environmental temperature range for charging is
60 °F to 95°F / 15 °C to 35 °C.
Indicator lights
The green charging light shows that the shaver is being
charged. When the rechargeable battery is fully charged,
the charging light goes off. If later on, the charging light
comes on again, this indicates that the shaver is being
recharged to maintain its full capacity.
The red low charge light glows when the battery capacity
has dropped below 20%, provided the shaver is
switched on. The remaining capacity will then be
sufficient for 2 to 3 shaves.
Preserving the cell unit
In order to maintain the optimum capacity of the
rechargeable battery, the shaver has to be fully dis-
charged (by shaving) every 6 months approximately.
Then recharge the shaver to full capacity again.
Shaving with the cord
If the rechargeable battery is discharged, you may
also shave with the shaver connected to the mains via
the low-voltage adapter (if the shaver does not run
immediately, turn it off and charge for approx. 1 minute).
Then shave with the cord connected.
6680
stop
6680
stop
FreegliderFreeglider
5710458_S4-34 Seite 7 Freitag, 8. August 2003 9:31 09
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 33 34

Comments to this Manuals

No comments