Braun 370cc User Manual download pdf (Page 10)

Important

Only use the power supply special cord set

supplied with the shaver.

In order to avoid any leakage of the

cleaning fluid, place the appliance on a flat,

stable surface. Do not tip, move suddenly

or transport in any way if a cleaning

cartridge is installed.

Do not place the appliance in a mirror

cabinet, nor store it over radiators, nor

place it on polished or lacquered surfaces.

Do not expose to direct sunlight.

The appliance contains highly

flammable liquid. Keep it away from

sources of ignition. No smoking.

Keep out of reach of children. Do not

refill cartridge. Use only original Braun refill

cartridge.

Description

1 Start/release button

2 Contact bow

3 Lift button for cartridge exchange

4 Level indicator

5 Cleaning cartridge

Before using Clean&Renew™

Installing the cartridge

Press the lift button (3) to open the housing.

Hold the cartridge down on a flat, stable

surface (e.g. table). Carefully remove the lid

from the cartridge. Slide the cartridge into

the base as far as it will go.

Slowly close the housing by pushing it

down until it locks.

Replacing the cartridge

After having pressed the lift button to open

the housing, wait for a few seconds before

removing the used cartridge.

Before discarding the used cartridge, make

sure to close the openings using the lid of the

new cartridge, since the used cartridge will

contain contaminated cleaning solution.

The used cartridge can be disposed in the

household waste.

•

Operating your

Clean&Renew™

Connect your Clean&Renew™ with the

cord set to the mains electricity supply.

The special socket at the back is adjust-

able to save space. After each shave,

switch the shaver off and put it into the

Clean&Renew™, upside down and with

the front showing.

Push the start/release button (1) to lock

and connect the shaver. The cleaning

process will start. The yellow light on the

shaver will flash during the complete

process (approx. 2 minutes cleaning,

4 hours drying).

Do not interrupt the cleaning process, as it

leaves the shaver wet and not fit for use. If

interruption is needed nonetheless, press

the start/release button (1).

When cleaning is finished, the yellow light

will go off and the shaver is ready for use.

To release it, push the start/release button.

A cleaning cartridge should be sufficient for

about 30 cleaning cycles. When the level

indicator (4) has reached the «min» mark,

the remaining fluid in the cartridge is

sufficient for about 5 more cleaning cycles.

Then the cartridge should be replaced,

when used daily approx. every 4 weeks.

The hygienic cleaning solution cartridge

contains alcohol which, once opened,

will naturally evaporate slowly into the

surrounding air. Each cartridge, if not used

daily should be replaced after approx.

8 weeks.

Clean the housing from time to time with a

damp cloth, especially the opening where

the shaver rests.

Accessories

Available at your dealer or Braun Service

Centers:

Foil & Cutter cassette: 32S

Cleaning cartridge Clean&Renew™: CCR

Subject to change without notice.

For electric specifications, see printing on the

special cord set.

•

98715711_Floater390cc_NA_S6-28.i10 1098715711_Floater390cc_NA_S6-28.i10 10 30.05.2008 12:51:05 Uhr30.05.2008 12:51:05 Uhr

1 ... 9 10 11 ... 26

Comments to this Manuals

No comments

Braun 370cc User Manual Page 10

Comments to this Manuals

Related products and manuals for Electric Shavers Braun 370cc