Braun A5 User Manual download pdf (Page 16)

Page 14

1500

Cycles

750

Cycles

Maintenance and Lubrication Schedule

continued

Perform all procedures listed in previous sections also

Resecure, replace damaged parts or otherwise

correct as needed. Note: Apply Light Grease to

Lift-Tite

™

latch tower pivot point if replacing latch.

Correct or replace damaged parts.

Remove foreign objects, replace damaged parts

and resecure as needed

Correct as needed.

Correct as needed.

Apply Light Oil - See Lubrication Diagram

Apply Light Oil - See Lubrication Diagram

Apply Light Oil - See Lubrication Diagram

Apply Grease (synthetic) to contact areas be-

tween upper/lower fold arms. See Lubrication

Diagram

Apply Light Oil - See Lubrication Diagram

Apply Light Oil - See Lubrication Diagram

Apply Light Oil - See Lubrication Diagram

Apply Light Oil - See Lubrication Diagram

Apply Light Oil - See Lubrication Diagram

Apply Light Oil - See Lubrication Diagram

Apply Light Oil - See Lubrication Diagram

Apply Light Oil - See Lubrication Diagram

Correct, replace damaged parts and/or relubri-

cate.

Correct, replace damaged parts and/or relubri-

cate.

Resecure, replace or correct as needed. See

Platform Angle Instructions and Floor Level

Adjustment Instructions.

Replace damaged parts.

Inspect Lift-Tite

™

latches and gas springs for wear

or damage (bent, deformed or misaligned), posi-

tive securement (external snap rings) and proper

operation

Inspect outer barrier for proper operation

Inspect platform fold gear rack and gear weldment

teeth for foreign objects, wear or damage (bent,

deformed or misaligned), positive securement and

proper operation

Inspect lift for wear, damage or any abnormal

condition

Inspect lift for rattles

Outer barrier activation foot pivot bearings (2)

Outer barrier pivot arm bearings (4)

Upper fold arm cam followers (4)

Upper/lower fold arms (2)

Platform pivot pin bearings (4)

Lower fold arm bearings (8)

Inner roll stop lever bearings (2)

Inner roll stop lever slot (2)

Saddle support bearings (8)

Parallel arm pivot pin bearings (16)

Handrail pivot pins (2)

Hydraulic cylinder pivot bushings (8)

Inspect Lift-Tite

™

latch rollers for wear or damage,

positive securement and proper operation (2)

Inspect outboard roll stop feet for proper opera-

tion, positive securement and detached or missing

torsion spring

Inspect inner roll stop for:

• Wear or damage

• Proper operation. Roll stop should just rest on

top surface of the threshold (base) plate.

• Positive securement (both ends)

Inspect handrail components for wear or damage,

and for proper operation

1 ... 15 16 17 ... 30

Comments to this Manuals

No comments