Braun 4745 User Manual download pdf (Page 6)

6

Description

1 Shaver foil

2 Cutter block

3 Release button

4 «on/off» switch

5 Long hair trimmer

6 Charging light

7 Special cord set

Charging

The best environmental temperature for char-

ging is between 60 °F to 95 °F/15 °C to 35 °C.

• Using the special cord set, connect the

shaver to an electrical outlet with the motor

switched off and charge it for at least

8 hours.

• As soon as you start charging the shaver,

the charging light (6) comes on.

• Once the shaver is completely charged,

discharge the shaver through normal use.

Then recharge to full capacity.

• A full charge will give up to 30 minutes of

cordless shaving time depending on your

beard growth. However, the maximum

battery capacity will only be reached after

several charging/discharging cycles.

• If the rechargeable batteries are dischar-

ged, you can shave without charging by

connecting the shaver to an electrical outlet

via the special cord set.

Shaving

Press the «on/off» switch (4) to turn the shaver

on.

Trimmer: When the long hair trimmer (5) is

activated, it allows controlled trimming of

moustache or sideburns.

Cleaning

The hand-held unit shall be detached from

the power supply cord before cleaning. The

shaver shall not be used until it has dried.

Regular cleaning ensures better shaving

performance. Rinsing the shaving head after

each shave under hot running water is an easy

and fast way to keep it clean:

• Switch the shaver on (cordless) and rinse

the shaving head under hot running water.

A natural based soap may also be used

provided it contains no particles or

abrasive substances. Rinse off all foam and

let the shaver run for a few more seconds.

• Next, switch the shaver off and press the

release buttons. Lift the shaver foil off and

pull the cutter block out. Then leave the

disassembled shaving parts to dry.

Alternatively, you may clean the shaver using

the brush provided:

• Switch the shaver off. Press the release

buttons and lift shaver foil off.

• Using the brush, clean the cutter block and

the inner area of the shaver head. However,

do not clean the shaver foil with the brush

as this may damage the foil.

Tips for the perfect shave

• It can take up to 14-21 days for your

beard to adjust to the new shaving

system.

• Shave before washing your face or taking

a shower, as skin tends to swell after

washing.

• The dryer the skin, the closer the shaving

results will be.

• Hold the shaver at right angles (90°) to the

skin. Stretch the skin and shave against

the direction of beard growth.

• To maintain 100% shaving performance,

replace your foil and cutter block every 18

months or when worn.

4745_NA_S4-18 Seite 6 Donnerstag, 2. Dezember 2004 3:26 15

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

Comments to this Manuals

No comments