Braun 390cc Series 3 User Manual download pdf (Page 6)

7

and a new calculation of the time when the

next cleaning is required will be started.

During the cleaning process in the

Clean&Renew™ the yellow light will flash and

will go off after approx. 4 hours when cleaning

is finished.

Automatic cleaning

Once the shaver is put into the

Clean&Renew™, it is cleaned automatically

(see separate instructions). Manual cleaning is

recommended only when the Clean&Renew™

is not available, e.g. when travelling.

Manual cleaning

This appliance is suitable for cleaning

under an open water tap.

Warning: Detach the hand-held part

from the power supply before cleaning it in

water.

Regular cleaning ensures better shaving

performance. Rinsing the shaving head after

each shave under running water is an easy and

fast way to keep it clean:

• Switch the shaver on (cordless) and rinse

the shaving head under hot running water.

A natural based soap may also be used

provided it contains no particles or abrasive

substances. Rinse off all foam and let the

shaver run for a few more seconds.

• Next, switch off the shaver, remove the

shaver foil and the cutter block. Then leave

the disassembled shaving parts to dry.

Alternatively, you may clean the shaver using

the brush provided:

• Switch off the shaver. Remove the shaver

foil.

• Using the brush, clean the cutter block and

the inner area of the shaver head. However,

do not clean the shaver foil with the brush as

this may damage the foil.

Replacement light for shaving parts / Reset

To maintain 100% shaving performance,

replace your foil and cutter block, when the

replacement light for shaving parts (9) comes

on (after about 18 months) or when worn.

Change both parts at the same time for a

closer shave with less skin irritation.

(Shaver foil (2) and cutter block (3):

31S)

The replacement light will remind you during

the next 7 shaves to replace the shaving parts.

Then the shaver will automatically reset the

display.

After you have replaced the shaving parts (foil

and cutter block), use a ball-pen to push the

reset button (10) for at least 3 seconds to reset

the display manually.

While doing so, the replacement light blinks

and goes off when the reset is complete. The

manual reset can be done at any time.

Preserving the batteries

In order to maintain the optimum capacity

of the rechargeable batteries, the shaver has

to be fully discharged (by shaving) every

6 months approximately. Then recharge the

shaver to full capacity. Do not expose the

shaver to temperatures higher than 50 °C for

extended periods of time.

Environmental notice

This product contains rechargeable

batteries. In the interest of protecting

the environment, please do not dispose

of the product in the household waste at the

end of its useful life. Disposal can take place

at a Braun Service Centre or at appropriate

collection points provided in your country.

Clean&Renew™

Braun Clean&Renew™ has been developed

for cleaning, charging and storing your shaver.

Clean your shaver daily in the Clean&Renew™.

During the automated cleaning process,

the shaver is switched on and off at intervals

to obtain best cleaning results. Since the

specially formulated cleaning fluid contains a

5735322_390_AMEE Seite 7 Montag, 19. November 2007 11:59 11

1 2 3 4 5 6 7 ... 57

Comments to this Manuals

No comments