Braun 7280 User Manual download pdf (Page 9)

9

6 Thoroughly clean the tweezers from the

rear side of the epilator head with the

brush dipped into alcohol. While doing so,

turn the tweezer element manually. This

cleaning method ensures best hygienic

conditions for the epilation head.

Cleaning under running water:

7 Remove the cap. Hold the appliance with

the epilation head under running water.

Then press the release button (5) to

remove the epilation head (2).

Thoroughly shake both, the epilation

head and the appliance to make sure that

remaining water can drip out. Leave both

parts to dry. Before reattaching, make sure

that they are completely dry.

B Using the shaver head

attachment

a OptiTrim comb

b Shaver foil

c Trimmer

d Release buttons

e Trim/shave selector

f Cutter block

g Shaver head base

Shaving

Put on the shaver head attachment (7) by

clicking it in.

Pressing one of the lock keys, turn the

switch clockwise to setting 2.

Make sure the trim/shave selector is in the

«shave» position.

For best results, always make sure that

both, the shaver foil (b) and the trimmer (c)

are in contact with the skin (A). Keeping

your skin stretched (B), slowly move the

appliance against the direction of hair

growth. The trimmer first raises all long

•

•

•

•

hairs and cuts them off. Then the flexible

foil follows to smooth away any stubble.

When shaving or trimming in sensitive

areas, make sure that you always keep

your skin stretched to avoid injuries.

Contour trimming

For trimming precise line and contours, lock

the long hair trimmer by sliding the trim/

shave selector (e) to the position «trim» (C1).

Pre-cutting hair for epilation

If you choose to pre-cut your hair to the ideal

length for epilation, place the OptiTrim comb

(a) onto the shaver head. Slide the trim/shave

selector to the «trim» position.

Hold the appliance with the OptiTrim comb

lying flat on the skin. Guide it with the comb

tips against the hair growth as shown in

illustration C2.

N.B. As hair does not always grow in the

same direction, also guide the appliance

slightly diagonally or in different directions in

order to achieve best results.

Cleaning the shaver head

After each use, unplug the appliance.

Brush cleaning

Press the release buttons (d) to remove the

shaver head (D1). Tap the bottom of the

shaver head gently on a flat surface (not on

the foil).

Brush out the cutter block and the inside

of the shaver head. However, do not clean

the shaver foil with the brush as this may

damage the foil.

Cleaning with water

Press the release buttons (d) to remove the

shaver head. Rinse the shaver head and the

•

•

•

98740802_SE_7280_IBERIA.indd 998740802_SE_7280_IBERIA.indd 9 17.07.2008 9:36:12 Uhr17.07.2008 9:36:12 Uhr

1 2 3 4 5 6 7 8 9 10 ... 34

Comments to this Manuals

No comments