Braun 5790 Flex XP II System User Manual download pdf (Page 10)

11

Description

1 Lift button for cartridge exchange

2 Contact bow

3 Start/release button

4 Level indicator

5 Cleaning cartridge

Before using Clean&Charge

Installing the cartridge

• Press the lift button (1) to open the housing.

• Hold the cartridge down on a flat, stable

surface (e.g. table). Carefully remove the lid

from the cartridge. Slide the cartridge into

the base as far as it will go.

• Slowly close the housing by pushing it down

until it locks.

Replacing the cartridge

After having pressed the lift button to open

the housing, wait for a few seconds before

removing the used cartridge.

Before discarding the used cartridge, make

sure to close the openings using the lid of the

new cartridge, since the used cartridge will

contain contaminated cleaning solution.

The used cartridge can be disposed in the

household waste.

Operating your

Clean&Charge

• Connect your Clean&Charge with the

special cord set to the mains electricity

supply. The special socket at the back is

adjustable to save space. After each shave,

switch the shaver off and put it into the

Clean&Charge, upside down and with the

front showing.

• Push the start/release button (3) to lock and

connect the shaver. The cleaning process

will start. The yellow light on the shaver will

flash during the complete process (approx.

5 minutes cleaning, 4 hours drying).

• Do not interrupt the cleaning process, as it

leaves the shaver wet and not fit for use. If

interruption is needed nonetheless, press

the start/release button (3).

• When cleaning is finished, the yellow light

will go off and the shaver is ready for use.

To release it, push the start/release button.

• A cleaning cartridge should be sufficient

for about 30 cleaning cycles. When the level

indicator (4) has reached the «min» mark,

the remaining fluid in the cartridge is suffi-

cient for about 5 more cleaning cycles. Then

the cartridge should be replaced, when

used daily approx. every 4 weeks.

• The hygienic cleaning solution cartridge

contains alcohol which, once opened,

will naturally evaporate slowly into the

surrounding air. Each cartridge, if not used

daily should be replaced after approx.

8 weeks.

• Clean the housing from time to time with a

damp cloth, especially the opening where

the shaver rests.

Subject to change without notice.

This product conforms to the European

Directives EMC 89/336/EEC and Low

Voltage 73/23/EEC.

For electric specifications, see printing on the

special cord set.

At the end of the product's useful life,

please dispose of it at appropriate

collection points provided in your

country.

Flex_XP_5790_MN Seite 11 Donnerstag, 30. November 2006 12:22 12

1 ... 9 10 11 ... 49

Comments to this Manuals

No comments