Braun 5790 Flex XP II System User Manual download pdf (Page 8)

9

A Shaver

Our products are designed to meet the

highest standards of quality, functionality and

design. We hope you enjoy your new Braun

shaver.

Warning

Your shaver is provided with a special cord

set with integrated Safety Extra Low Voltage

power supply. Therefore you must not ex-

change or manipulate any part of it. Otherwise

there is a risk of electric shock.

Description

1 Shaver foil

2 Cutter block

3 Release button

4 On/off switch («start/stop»)

5 Long hair trimmer

6 Charging light (green)

7 Cleaning light (yellow)

8 Special cord set

Charging the shaver

•

Using the special cord set, charge the shaver

directly off the mains for at least 8 hours

(shaver and special cord set might get warm).

• With normal use the shaver will be charged

automatically after every cleaning in the

Clean&Charge (see section B).

• The green charging light indicates that the

shaver is being charged.

• A full charge will give up to 40 minutes of

cordless shaving time depending on your

beard growth. However, the maximum

battery capacity will only be reached after

several charging/discharging cycles.

• Best environmental temperature range for

charging is 15 °C to 35 °C.

• When fully discharged, you may also shave

with the shaver connected to the mains via

the special cord set.

Shaving

Turn on the shaver («start»):

The pivoting cutting system automatically

adjusts to every contour of your face.

Trimmer:

When the long hair trimmer is activated, it

allows the controlled trimming of moustache

or sideburns.

Keeping your shaver in top

shape

Cleaning indicator

Your shaver should be cleaned daily in the

Clean&Charge, and certainly when the yellow

cleaning light shines constantly after shaving.

If this is not done, the yellow light will go off

after some time. The shaver‘s electronics will

then assume it has been cleaned manually

and a new calculation of the the time when the

next cleaning is required will be started.

During the cleaning process in the

Clean&Charge the yellow light will flash and

go off after approx. 4 hours when cleaning is

finished.

Automatic cleaning

Once the shaver is put into in the

Clean&Charge, it is cleaned automatically (see

section B). Manual cleaning is recommended

only when the Clean&Charge is not available,

e.g. when travelling.

Tips for the perfect shave

• We recommend that you shave before

washing, as the skin tends to be slightly

swollen after washing.

• Hold the shaver at right angles (90°) to the

skin. Stretch the skin and shave against

the direction of beard growth.

• To maintain 100% shaving performance,

replace your foil and cutter block every

18 months or when worn.

English

Flex_XP_5790_MN Seite 9 Donnerstag, 30. November 2006 12:22 12

1 2 3 4 5 6 7 8 9 ... 49

Comments to this Manuals

No comments