Braun 5790 Flex XP II System User Manual download pdf (Page 9)

10

Manual cleaning

This appliance is suitable for cleaning

under an open water tap.

Warning: Detach the hand-held part

from the power supply before cleaning it in

water.

Regular cleaning ensures better shaving

performance. Rinsing the shaving head after

each shave under running water is an easy and

fast way to keep it clean:

• Switch the shaver on (cordless) and rinse

the shaving head under hot running water.

A natural based soap may also be used

provided it contains no particles or abrasive

substances. Rinse off all foam and let the

shaver run for a few more seconds.

• Next, switch off the shaver, remove the

shaver foil and the cutter block. Then leave

the disassembled shaving parts to dry.

Alternatively, you may clean the shaver using

the brush provided:

• Switch off the shaver. Remove the shaver

foil.

• Using the brush, clean the cutter block and

the inner area of the shaver head. However,

do not clean the shaver foil with the brush as

this may damage the foil.

Replacing the shaving parts

To maintain 100% shaving performance,

replace your foil and cutter block every 18

months or when worn. Change both parts at

the same time for a closer shave with less skin

irritation.

(Shaver foil and cutter block:

part no. 5000/6000)

Preserving the batteries

In order to maintain the optimum capacity of

the rechargeable batteries, the shaver has to

be fully discharged (through normal use) every

6 months approximately. Then recharge the

shaver to full capacity. Do not expose the

shaver to temperatures higher than 50 °C for

extended periods of time.

Environmental notice

This product contains rechargeable

batteries. In the interest of protecting

the environment, please do not dispose

of the product in the household waste at the

end of its useful life. Disposal can take place

at a Braun Service Centre or at appropriate

collection points provided in your country.

B Clean&Charge

Braun Clean&Charge has been developed for

cleaning, charging and storing your shaver.

Clean your shaver daily in the Clean&Charge.

During the automated cleaning process, the

shaver is switched on and off at intervals to

obtain best cleaning results. Since the spe-

cially formulated cleaning fluid contains a

small amount of oil, the cleaning procedure

also fulfills the lubrication needs of the shaver.

Important

• Only use the special cord set supplied with

the shaver.

• In order to avoid any leakage of the cleaning

fluid, place the appliance on a flat, stable

surface. Do not tip, move suddenly or trans-

port in any way if a cleaning cartridge is

installed.

• Do not place the appliance in a mirror cabi-

net, nor store it over radiators, nor place it

on polished or laquered surfaces. Do not

expose to direct sunlight.

• The appliance contains highly flamma-

ble liquid. Keep it away from sources

of ignition. No smoking. Keep out of reach

of children. Do not refill cartridge. Use only

original Braun refill cartridge.

• When cleaning the shaver, its protection

cap should be removed.

Flex_XP_5790_MN Seite 10 Donnerstag, 30. November 2006 12:22 12

1 2 3 4 5 6 7 8 9 10 ... 49

Comments to this Manuals

No comments